Dense Phase Pneumatic Conveying


Highly abrasive or very fragile material can require lower speed conveyance and a higher product-to-air ratio. From production to installation, our proven dense phase systems keep your line moving.

SMOOT

Filter Sort

Just Hit START to Convey Abrasive or Fragile Material

Abrasive or fragile materials’ lower speed, higher pressure and higher product-to-air ratio requirements are nothing new to us. Dense phase pneumatic conveying is less common than comparable dilute phase because of the greater capital investment involved if there is no need to be concerned about breakage or wear. Dense phase systems are more commonly powered by higher pressure (~100 PSIG) and higher horsepower air compressions, making them more costly to operate, so it’s even more critical they run efficiently and reliably when you hit START.

Our Patented Bypass Valve Eliminates Compressed Air Line Boosters

A dense phase transmitter or DPT is at the heart of most high-pressure systems, commonly known as a pressure vessel or blow pot. The DPT is where the product is filled and pressurized to begin the convey cycle. Our patented bypass valve controls our dense phase conveyors and operates without cumbersome and expensive compressed air line boosters. The bypass valve controls the material-to-air ratio by diverting the conveying air around the pot if convey pressures rise too high. This is usually a result of too much material in the line, causing an off-balanced material-to-air ratio. By diverting the air around the pot, material flow is slowed, and the ratio is reduced by air going directly to the pneumatic conveying line.

More Dense Phase Pneumatic Conveying Benefits:

  • Less susceptible to leakage and wear.
  • Operate at high pressure.
  • Integrates with batch weighing applications.

Blog Articles Related to Dense Phase Pneumatic Conveying: